Dodge Ram: How to Replace Tail Light Bulbs and Assembly

Dodge Ram: How to Replace Tail Light Bulbs and Assembly
Fixing the fag end light on a Dodge Ram is thus simple anyone can do it. This how-to will guide you through replacing the buttocks abstemious bulb and assembly. This article applies to the Dodge Ram ( 1994-present ) .
Fixing a break or burned out buttocks light is important and can get you into trouble if you do n’t fix it adenine soon as possible. thankfully, it is neither expensive nor difficult to fix. Anybody can fix a buttocks light, and you can, excessively, if you follow the instructions in this article .
Dodge Ram: How to Replace Tail Light Bulbs and Assembly

Materials Needed

  • Replacement tail light bulb and/or assembly
  • T25 Torx screwdriver
  • Phillips screwdriver
  • Soft pry tool (optional)

Step 1 – Remove the tail light assembly

Open the tailgate on your hand truck and you ‘ll see two T25 Torx screws adjacent to the tail light assembly merely below the the tailgate hinge. All you have to do is remove these two screws then you can equitable pull the tail faint forum from the truck. If you ‘re having trouble getting it to come out, you can try prying it off. Make certain to only use a soft pry tool so you do n’t scratch the paint on the hand truck. once you have it loosened you ‘ll need to unplug the electrical harness. Pry out the fiddling red clip on the rule then squeeze the end of the harness to pull it out.

Dodge Ram: How to Replace Tail Light Bulbs and AssemblyFigure 1. Undo the two Torx screws.

Pro Tip

Newer truck models starting from the ’08 model have the harnesses directly attached to the bulb sockets. Simply twist the bulb sockets counter-clockwise to remove them from the stern light assembly.

Step 2 – Replace the tail light bulb and assembly

Use a Phillips screwdriver to remove the four screws holding the bulb circuit plate to the dock light assembly. Pull out the plate and find the bulb you need to replace. Just pull the bulb out and insert the raw one. You should hear it click into place. After that, it ‘s barely the invert process to install the forum :

  • Attach the bulb circuit plate to the tail light assembly and tighten the four Phillips screws.
  • Connect the electrical harness and reattach the red clip to the harness.
  • Line up the pins on the tail light assembly to the holes in the side of the truck and insert the assembly to the truck.
  • Tighten down the two T25 Torx screws.

Be sure to take the time to test the medulla oblongata and make certain they work. Remember that if one light bulb has burned out, the other could be on its direction out so it may be best to replace the opposite bulb american samoa well .

  • Dodge Ram: How to Replace Tail Light Bulbs and AssemblyFigure 2. Remove these four Phillips screws.
  • Dodge Ram: How to Replace Tail Light Bulbs and AssemblyFigure 3. Just pull the bulb to remove it.

Warning

Be careful when handling the bulb good after driving the hand truck because they can get very hot when they ‘ve being used .

Featured Video: How To Change Your Dodge Ram Tail Light Bulbs (’99 to ’07)

Related Video

source : https://tonupboys.com
Category : Car Brakes