- Previous Topic
- Next Topic
- Download PDF
- Print Page
You can use the out-front mount to install the headlight and your Edge® device. Garmin recommends that you adjust the mount for the Edge viewing angle before you install and adjust the headlight angle.
- Select a secure location to mount the Edge device and headlight where they do not interfere with the safe operation of your bike.
- Use the 2.5 mm hex key to remove the screw
from the handlebar connector .
[external_link_head]
- If necessary, remove the two screws on the top of the mount , rotate the connector, and replace the screws to change the orientation of the mount for an Edge device.
- Place a rubber pad around the handlebar:
-
If the handlebar diameter is 25.4 mm, use the thicker pad.
-
If the handlebar diameter is 31.8 mm, use the thinner pad.
[external_link offset=1]
-
- Place the handlebar connector around the rubber pad.
NOTE: You should align the contours on the rubber pad with the grooves on the inside of the handlebar connector.
- Replace the screw, and use the 2.5 mm hex key to tighten the screw.
NOTE: You should check the tightness of the screw periodically.
- Install the Edge device, and adjust the mount (optional).
- Connect the quarter-turn adapter to the headlight.
- Insert the screw , and hand tighten.
[external_link offset=2]
- Align the notches of the quarter-turn adapter with the tabs on the bottom of the mount.
- Press up slightly, and turn the adapter counterclockwise until it locks into place.
- Adjust the headlight angle so it is parallel to the ground, and use the 4 mm hex key to tighten the screw.
NOTE: You should check the tightness of the screw periodically.
[external_footer]