How To Easily Bypass & Connect Ripspeed DV720 Head Unit Handbrake Wire

How To Easily Bypass & Connect Ripspeed DV720 Head Unit Handbrake Wire
If you have installed an Ripspeed dv720 in car DVD actor and you want to allow your passengers to watch music or movies on a DVD, while your drive your fomite, then you will need to bypass the handbrake wire, besides know as the parking electrify. You will have to bypass it, so then the in car DVD player thinks that the handbrake is positioned upwards and you have parked up. If you have connected the handbrake wire, how the manufacturer told you to, by connecting it to the handbrake trade, that is the correct method acting, however when you are driving it wo n’t play DVD ‘s. This is because the police do n’t want you to get distracted, while you are driving because your eyes wo n’t be watching the road, as you will be focused on the screen, alternatively of focusing on the road and you are very likely to cause an accident.
( This usher provided to you below besides works with most in car videodisk player head units brands, including the ones made by Alpine, Clarion, Kenwood and Pioneer )

1) Switch off the car ‘s ignition off, so the ability to the point unit is turned off, allowing you to work with wires safely.
2) OK, First of all you will need to remove the head unit from the vehicle ‘s one boom slot. so remove the credit card reduce that goes around it, by clipping it off on each side, it will them come off and then place it to one side. then you will need to remove the deck from the mount batting cage, this is by inserting an flat head screwdriver into each sides, to pry it out of the mount batting cage.
3) then grip the front of the steer whole with both hands holding it securely and pull it out slowly. You can now access the electrify harness and find the handbrake wire. then cut off the wire that is leading down the cable car to the handbrake switch over, using a ‘wire stonecutter ‘ or use a match of handy scissors, as you wo n’t be needing it.

4) Once it is cut, then locate the parking wire that is connected into the wiring harness fireplug, it will be a tap color thin gauge wire and will normally have an minor label attached onto it saying it is an handbrake cable. But if you bought the stereo secondhand then it might not have an label, as it might be faded or torn off.
5) Using a ‘wire stripper ‘ remove about 1cm of credit card insulation coating off the pink wire. then connect that electrify to the black wire, which is the establish for the head whole, found on the wiring harness, that is connected to the vehicle ‘s metal chassis. This is by twisting the tap wire ‘s copper braid with the braid from the black cable, hard together to make an guarantee joining. When you ‘re done, then magnetic tape it up using electrical insulation tape, to prevent the wires touching early wires and causing a short. indeed now that you have set up the wire, it will trick the in car DVD actor, to think that the handbrake is positioned up, allowing it to play DVDs when drive.

6) Place the radio back into the boom slot, push button all the wires second and push it forward, so it goes all the way down into the ride cage and locks in. then replace the fictile trim, by placing it around the front panel and pushing it down until it clicks .

source : https://tonupboys.com
Category : Car Brakes